加熱包.電熱包使用須知The electrothermal package Use
1.確認電源電壓為110V或220V。
2.切勿將水或溶液倒入電熱包，影響電熱包壽命。
3.此電熱包在第一次加熱使用時，其表面之水分及臘質等成分會被蒸發掉，而產生白煙，且其纖維布表面變黑，經過約20～30分鐘蒸發後，其表面會還原為白色。（只有第一次使用會有此現象）
4.有附調溫器，請將調溫器調至最大，以利快速蒸發。
5.電熱包其內部表面溫度約為450°C 左右，使用時請小心為要、安全第一。
1.Make sure the power supply voltage of 110V or 220V.
1.Make sure the power supply voltage of 110V or 220V.
2.Do not water or solution into the electric package, the impact
of electric packagelife.
3.This electric package in the first heating is used, the composition of the surfacewater and waxy evaporated and white fumes are generated, and the surface of thefiber cloth is black, after about 20 to 30 minutes after evaporation, the surface willrevert to white. (Only for the first time this phenomenon will be)
4.attached to the thermostat, set the thermostat to the maximum, in order to facilitate the rapid evaporation.
5.Electric package its internal surface temperature of approximately about 450 ° C,careful you want to use, safety first.
3.This electric package in the first heating is used, the composition of the surfacewater and waxy evaporated and white fumes are generated, and the surface of thefiber cloth is black, after about 20 to 30 minutes after evaporation, the surface willrevert to white. (Only for the first time this phenomenon will be)
4.attached to the thermostat, set the thermostat to the maximum, in order to facilitate the rapid evaporation.
5.Electric package its internal surface temperature of approximately about 450 ° C,careful you want to use, safety first.
留言
張貼留言